Xbox 360 - Wii Konsolen Umbau Modchip Einbau

Firmware update for the remote to solve the "always on" when receiving power in standby mode.

Firmware Updater for xk3y Remote

Contents:
xupper.exe - An old DriveKey tool, we are reusing the bootloader in the remote & this tool can update it.
remote_1_1A.upd - The FW update file

To use:
1. Unpack the rar file

2. Plug your remote into PC, holding down the up & down buttons while plugging in. The display will stay blank and the blue LED will light

3. Run xupper.exe, it should detect the remote and display "Connected: Firmware update mode" and "Updater v 1.3"

4. In the top menu bar select "File | Open", select "Programmer Updates (.upd)" in the file filter and load file "remote_1_1A.upd"

5. In the top menu bar select "Programmer | Update Programmer Firmware" & the update will run, takes about 10 seconds & the display turns on

6. You're done! Disconnect the remote and use as normal.

V1.1
R7 users:
-The remote display will turn on when initially connected (or remain on when the console turns off) for 30 seconds and then turn off.
-When the console is off pressing a button on the remote will cause the display to turn on again for 30 seconds

R6&R7 users:
When the console is turned on the remote display will turn on shortly afterwards.
The remote display will turn off 30 seconds after 30 seconds of inactivity, it will turn back on when a button is pressed.