1. Make sure that your CK3 is installed correctly and a COM port is showing. This example shows that the CK3i is on COM 2. Make sure that the CK3 is hooked up to the ISP port on the NAND-X.

Easy step by step guide on programming a NAND-X with the latest NANDPRO Software.

This guide is essentially for people who already own a CK3 Pro or CK3i. If your sole purpose is to just program an Xecuter CoolRunner and you don't own a CK3i or CK3 Pro then we would recommend you buy the standalone USB to NAND-X ISP Update Cable which will be on sale towards the end of November. If you cant wait then go ahead and get a CK3i - it's one of the most popular products in any modders toolbox anyway

We do provide a CK3 to NAND-X ISP Update Cable, however you can make one yourself if you wish. You can simply use one of the cables that comes with the NAND-X and chop it up to suit your needs. Here's some instructions (Do not ask question in this thread about DIY parts - this thread is for the officially manufactured products only)

Requirements:

Xecuter NAND-X (Buy Here)
CK3i or CK3 Pro (Buy Here)
CK3 to NAND-X Update Cable (Buy Here)
Flash Magic Software (Download Here)
NANDPRO v3 (Download Here)

Tip

You can try a higher baud rate if you want to go much faster. 9600 is the flat standard but its slow - but you can go as high as 320000 and it will do it start to finish in seconds

1. Make sure that your CK3 is installed correctly and a COM port is showing. This example shows that the CK3i is on COM 2. Make sure that the CK3 is hooked up to the ISP port on the NAND-X.





2. Install the FlashMagic software. Make sure all the settings are as the picture below.

Step 1:

• Select Device: (LPC2148)
• COM Port: (Whatever your CK3 is)
• Baud Rate: 9600
• Interface: None (ISP)
• Oscillator (MHz): 12 (If you have problems set it to 14.745)

Step 2:

• Tick Erase Blocks Used By Hex File

Step 3:

• Load the ArmV3.hex that came with NandPro 3 (Thanks Tiros!)

Step 4:

• Tick Verify After Programming

Step 5: Now hit START!

CK3 Pro / Blaster CK3 Installshield Driver Setup Program
*Fixed Problems with "Cant Copy Inf File" Errors*
Installer version & Build date: 1.2.225 (2010-07-19)
Windows 98/ME Driver: v2.0.0.19
Windows 2000/XP/Server2003 (32 & 64-bit) WDM WHQL Driver: v2.0.13.130
Windows Vista/7/Server2008 (32 & 64-bit) WDM WHQL Driver: v3.3.10.140
NOTE: For Windows 7, please use RC build 7100 or RTM 7600 Final version. (Installer program will not run on early Windows 7 or Beta versions)
This driver is to be used only if you are connecting to a Liteon 74850C.

These are the USB drivers for the new Xecuter CK3i. Compatible with WIN XP/Vista/& 32bit & 64 Bit